[. . . ] It splits a networked PoE signal into separate power and data sources. [. . . ] Run an Ethernet cable from a PoE switch (or injector) for distances up to 100 meters and then split the PoE signal into separate data and power sources in order to network a non-PoE device. Save installation and equipment cost when installing access points, IP cameras, and more in a remote location. A handy toggle switch adjusts output power to 5V, 7. 5V, 9V, or 12V in order to match non-PoE device power requirements. 90% (non-condensing) · CE, FCC Switch Power Power Consumption Jumper Cable Dimensions Weight Temperature Humidity Certifications NETWORKING SOLUTIONS PACKAGE CONTENTS TPE-114GS Quick Installation Guide 2 x Jumper Cable (2. 0 x 2. 0mm, 2. 0 x 2. 5 mm) RELATED PRODUCTS TPE-103I TPE-S44 TPE-114GS Power over Ethernet (PoE) Injector 8-Port 10/100Mbps PoE Switch Gigabit Power over Ethernet (PoE) Splitter CONTACT INFORMATION 20675 Manhattan Place, Torrance, CA 90501 USA Tel: 1-310-961-5500 Fax: 1-310-961-5511 Web: www. trendnet. com Email: sales@trendnet. com 1-888-326-6061 TRENDnet is a registered trademark. Other Brands and product names are trademarks of their respective holders. Information provided in this document pertain to TRENDnet products and is subject to change at any time, without notice. [. . . ] Information provided in this document pertain to TRENDnet products and is subject to change at any time, without notice. [. . . ]